Aligning The Appliance - Miele F 1471 Vi Operating And Installation Manual

Aligning the appliance

^ Align the appliance with the custom
front.
The installation aids e have been
designed for the following total
thicknesses of custom doors:
3
– / " (19 mm)
4
1
– 1 / " (38 mm)
2
Be sure to take into account the
possible differing thicknesses of the
custom door that is to be fitted
subsequently.
The height-adjustable feet at the front
and rear can all be adjusted from the
front.
– Front: with an open-ended wrench
½" (SW 13).
The feet can be adjusted from the
top and bottom f.
5
– Rear: with a /
16
driver via flexible shaft g.
" (8 mm) hex nut
Installing the appliance
A mark is located on the appliance
base and is used as a standard gauge
for height adjustment. When adjusting
the height, align this mark at 1
(32 mm) above the floor.
^ Place a marking-out level over the
installation aids e on the door.
^ Unscrew the height-adjustable feet
until the mark on the base has
reached the indicated guide
1
dimension 1 /
4
It is very important to comply with
this dimension for the subsequent
alignment of the custom door fronts.
^ Align the custom door with a level.
1
/ "
4
" (32 mm).
65