Table of Contents
Advertisement
Building in the appliance
Aligning the appliance
^ Hold the plinth facing at the side and
pull it forwards and off.
With a building-under height of
820 mm the adjustable feet must not
be extended.
With a building-under height of more
than 820 mm the feet must be
extended. For example, with a
building-under height of 870 mm, the
feet must be extended by approx.
50 mm.
^ Adjust the feet according to the
height of the niche and make sure
the appliance is level.
The appliance should be aligned so
that it fits fairly tightly between the
floor and the worktop.
Proceed as follows:
^ Adjust both rear feet using
appropriate screws a at the front
right and left in the appliance plinth.
40
^ Use an allen key to unscrew both
front feet.
As soon as the feet have been
unscrewed slightly, you can also
adjust them with a screwdriver at the
bottom of the foot (see small
illustration above).
^ Insert the piece of foam rubber
supplied a. Important. This ensures
optimum air flow and prevents
malfunctioning
^ Refit the plinth facing and pull it
forwards until the ventilation slats are
in alignment with the neighbouring
furniture plinths.
^ Hold the plinth facing securely and
attach it on the right and left using
the bolts supplied b.
Advertisement
Table of Contents
