Remove two nuts from
one end of the top panel
frame. Remove end
piece. Slide decorative panel into
Replace end piece
top grille is aligned with
top trim on cabinet. Use
six. screws to iighten top grille frame
Check that the power
switch is in the "ON" position.
Attach top grille decorative panel
assembly to the keyhole bracket on
the frame and pull down to secure.
If the top grille decorative panel
does not fit evenly within frame, the
keyhole bracket can be moved side
to side by adjusting the bracket
screws or the decorative panel
bracket can be moved up or down
by adjusting the decorator panel
Personal Injury Hazard
Reinstall set screws after
door swing Is set.
Fallure to do so could result
In personal Injury.
Check that doors can
open freely. If not, the
door stops or hinges
can be adjusted.
screw in top and bottom hinges with
Determine the door
Hold door in that
position and tighten the set screws.
The doors have stops at 90°, 115"
and 137O positions.
If the door
stops cannot be adjusted to clear
need to be mitered. (Consult your
builder to adjust countertops.)
not remove, top and bottom hinge
screws. Lift door and bottom hinge
to desired position. Tighten bottom
hinge screws and then top hinge
Check the water
bottom of the refrigerator
again for leaking. Any leaking can
cause refrigerator and floor damage,
Open both doors. Use
two screws to attach
bottom grille to cabinet.
Put shelves and bins
into the refrigerator and
Remove protective film from door
Set refrigerator and
controls to the midpoint between
"COLD" and "COLDEST".
that the compressor
Check that all five interior
lights are working.
To get the most efficient
use from your new
built-in re frigera tar, read
and Care Guide. Keep
and Guide close to
built-in refrigerator for