Energy And Water Saving Tips; How To Add A Dish During A Cycle - Kenmore 363.14151 Use & Care Manual

Normal Sights and Sounds
• You'll see water vapor coming through
the vents by the door latch during drying
and when water is being pumped out.
• You'll hear occasional sounds while your
dishwasher is running:
• Soft food disposer shredding action.
o Drain valve opening to pump water
out.
o Timer control as cycle progresses.
o Detergent cup opening,
o Pump motor starting.
o The motor stops during drying.
Energy and Water Saving Tips
o Wash full loads.
• Use your dishwasher during off-peak
hours.
o Use the LIGHT WASH cycle whenever
possible,
o Select HEATED DRY OFF drying option
when you don't need dry dishes in a
hurry.
o Don't prerinse normally soiled dishes.
° Load correctly to ensure good washing
action,
How to Add a Dish During
a Cycle
• Add dishes any time during RINSE &
HOLD cycle.
o With other wash cycles, you can add
dishes at any time BEFORE the
detergent cup has opened.
Here's how to add a forgotten dish:
1. Push door latch to the left, Washing
will stop.
2. Wait a few seconds until the water
calms, Then open the door.
3. Add dishes you've forgotten.
Preparing Dishes for Washing
. Prerinsing of normal food soil is not
necessary_
- Scrape off bones, seeds, skins,
toothpicks, and other hard soil&
o Remove hard shelled vegetables,
meat trimmings, leafy vegetables, and
excessive amounts of oil or grease.
. Remove foods with high acid content--
they can discolor stainless steel.,
o Remove large quantities of any food.
o When using the POTS PANS cycle,
less preparation is required. This cycle
can wash heavily-soiled dishes and
remove dried-on and baked-on soils
from pots, pans, and casseroles.
However, items with burned-.on soils
may not come clean.
lO