Extension Table; Detaching The Table; Attaching The Table; Accessory Box - Kenmore 385.15510200 Owner's Manual

Extension Table
• Detaching the table
Pull the table away from the machine, as illustrated, for
"free-arm" sewing of cuffs and sleeves.
• Attaching the table
Push the extension table until it snaps into the machine.
(_ Extension table
Pin
Hole
_Tab
Free-arm
• Accessory box
Open the cover of the accessory box toward you.
Sewing accessories are conveniently located in the box.
Changing Needle
(_ Needle ctamp screw
Needle clamp
Turn offthe power switch.
Raise the needle to its highest position by turning the
handwheet counterclockwise, toward you, and lowering
the presser foot. Loosen the needle clamp screw (_ by
turning it counterclockwise. Remove the needle from the
needle clamp _.
Insert a new needle into the needle clamp @ with the
flat side to the rear. When inserting the needle into the
needle clamp _, push it up as far as it goes. Tighten
the needle clamp screw (_ firmly by turning it clockwise.
To see if the needle is good, place the flat side of the
needle onto something fiat (e.g needle plate or glass).
The gap between the needle and the flat surface should
be consistent. Never use a bent or blunt needle.
A damaged needle can cause permanent snags or runs
in knits, fine silks and silk-like fabrics.
To Remove and Attach the Foot Holder
(_ Thumb screw
Foot holder
Presser bar
• To remove
Remove the thumb screw _ by turning it counterctock
wise with a screwdriver.
• To attach
Match the hole in the foot holder _ with the threaded
hote in the presser bar _. Fit the thumb screw _ into
the hole. Tighten the screw _ by turning it clockwise with
screwdriver.
S
s
f
/
\
Flat side 1
Lado piano Needle
I
Uep!at -- Aguja /
Ague 1
I
%
J
J
lO