Electrical Connections - LG LCE30845 Owner's Manual

Ceramic-glass induction cooktop
Hide thumbs Also See for LCE30845:
Table of Contents

Advertisement

iNslaiialioN iNSIRUcliONS
ELEcTRicAL cONNEcTiONS
IMPORTANT
SAFETY INSTRUCTIONS
Be sure your cooktop is installed and grounded
properly by a qualified installer or service
technician.
This cooktop must be electrically grounded in
accordance
with local codes or, in their
absence, with the National Electrical Code
ANSI/NFPA No. 70, latest edition in the
United States.
WARNING
The electrical power to the cooktop must be
shut off while line connections are being
made. Failure to do so could result in
serious injury or death.
PROVIDING
THE
ELECTRICAL CONNECTION
Install the junction box under the cabinet and run
120/240 or 120/208 volt, AC wire from the main
circuit panel.
NOTE: DO NOT connect the wire to the circuit
panel at this time.
ELECTRICAL REOUIREMENTS
Observe all governing
codes and local
ordinances.
A 3-wire or 4-wire single-phase
120/240 or
120/208 volt, 60 Hz AC-only electrical supply
is required on a separate circuit fused on
both sides of the line (time-delay fuse or
circuit breaker is recommended).
DO NOT
fuse neutral. The fuse size must not exceed
the circuit rating of the appliance specified on
the nameplate.
O
This unit can consume
up to 7,400W at
240 VAC. A 40 Amp circuit breaker with wire
gauge #8 AWG must be used.
NOTE: Wire sizes and connections
must
conform with the fuse size and rating of the
appliance in accordance
with the National
Electrical Code ANSI/NFPA
No. 70, latest
edition, and local codes and ordinances.
The appliance should be connected
to the
fused disconnect
(or circuit breaker) box
through flexible armored or nonmetallic
sheathed cable. The flexible armored cable
extending from this appliance should be
connected directly to the grounded junction
box. The junction box should be located as
shown on page 22 with as much slack as
possible remaining in the cable between the
box and the appliance, so it can be moved if
servicing is ever necessary.
A suitable strain relief must be provided to
attach the flexible armored cable to the
junction box.
WARNING
An extension cord must not be used with
this appliance.
Such use may result in a fire,
electrical
shock, or other personal injury.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hn7413agHnagLce

Table of Contents