Choke Cable Adjustment; Reverse Gate Mechanism Inspection; Fuse Replacement - Yamaha EXCTER220 Owner's Manual

4
M
AINTENANCE

CHOKE CABLE ADJUSTMENT

Pull the choke knob out until it stops.
Release the knob. The knob should not
move. If it moves back on its own, tight-
en the friction adjustment slightly. If the
knob is difficult to move, loosen the fric-
tion adjustment slightly.
REVERSE GATE MECHANISM
INSPECTION
1. Remove the engine stop switch lan-
yard and ignition keys.
2. Put the throttle levers in the idle
position (otherwise the shift lever
will not move).
3. Push the shift lever to Forward from
the Neutral position while a second
person observes shift gate move-
ment from outside the boat. Both
shift gates should lift completely to
the stops.
4. Pull the shift lever back from
Forward through
Reverse. The observer should
& C
ARE
R
L
Neutral to
4-14
check for proper movement of the
shift gates. Both gates should drop
down over the nozzles to the stops.
If reverse gates do not operate smooth-
ly or correctly, ask your authorized
Yamaha Jet Boat dealer for service.

FUSE REPLACEMENT

1
The fuse is in the ignition coil holder. To
replace the fuse, pull out the grommet
connected to two red leads, and bring
it out with the fuse box. Open the fuse
box and replace the fuse.
➀
Ignition coil holder
➁
Grommet
➂
Fuse (10A)
Accessory Fuse
1
➁
1 Fuse (20A)
2 Accessory lead
The fuse is on the accessory battery
lead wire (red with black stripe). To
replace the fuse, open the fuse box
and replace the fuse.
3
3