Yamaha YZF-R6S(C) Owner's Manual page 76

PERIODIC MAINTENANCE AND MINOR REPAIR
1. Drive chain slack
4. If the drive chain slack is incorrect,
adjust it as follows.
To adjust the drive chain slack
6
1. Loosen the axle nut and the lock-
nut on each side of the swingarm.
2. To tighten the drive chain, turn the
adjusting bolt on each side of the
swingarm in direction (a). To loos-
en the drive chain, turn the adjust-
ing bolt on each side of the
swingarm in direction (b), and then
push the rear wheel forward.
NOTE:
Using the alignment marks on each
side of the swingarm, make sure that
both chain pullers are in the same posi-
tion for proper wheel alignment.
EAU22940
1. Axle nut
2. Drive chain slack adjusting bolt
3. Locknut
4. Alignment marks
CAUTION:
Improper drive chain slack will over-
load the engine as well as other vital
parts of the motorcycle and can lead
to chain slippage or breakage. To
prevent this from occurring, keep
the drive chain slack within the
specified limits.
6-30
3. Tighten the locknuts, and then
tighten the axle nut to the specified
torque.
Tightening torque:
Axle nut:
110 Nm (11.0 m·kgf, 80 ft·lbf)
ECA10570