Troubleshooting - Yamaha YZF-R6S(C) Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
G
Make sure that there is enough
space between the brake pads be-
fore installing the wheel.
1. Retainer
2. Slot
6
2. Install the drive chain onto the rear
sprocket, and then adjust the drive
chain slack. (See page 6-29.)
3. Install the axle nut, and then lower
the rear wheel so that it is on the
ground.
4. Tighten the axle nut to the speci-
fied torque.
Tightening torque:
Axle nut:
110 Nm (11.0 m·kgf, 80 ft·lbf)

Troubleshooting

Although Yamaha motorcycles receive
a thorough inspection before shipment
from the factory, trouble may occur dur-
ing operation. Any problem in the fuel,
compression, or ignition systems, for
example, can cause poor starting and
loss of power.
The following troubleshooting charts
represent quick and easy procedures
for checking these vital systems your-
self. However, should your motorcycle
require any repair, take it to a Yamaha
dealer, whose skilled technicians have
the necessary tools, experience, and
know-how to service the motorcycle
properly.
Use only genuine Yamaha replace-
ment parts. Imitation parts may look like
Yamaha parts, but they are often inferi-
or, have a shorter service life and can
lead to expensive repair bills.
6-44
EAU25870