Intel Ether express PRO/100+ TX PCI model B Installation Manual page 10

Note:
To run the PROSet utility at
any time, go to the
Adapters tab in the Network
control panel and click
Properties.
6 Intel EtherExpress PRO/100+ TX PCI LAN Controller User's Guide
Install Network Drivers - Windows NT Version 4.0 Only
After enabling the ehternet controller in the computer and starting Windows
NT, you need to install the correct drivers.
Installing Windows NT 4.0 Drivers
Double-click the Network icon in the Control Panel.
1.
Click the Adapters tab.
2.
Click Add. You'll see a list of adapters.
3.
4. Don't select an adapter from this list. Instead, insert the Configuration
and Drivers disk into your floppy drive and click Have Disk.
Type A:\ in the dialog box and click OK. Then follow the instructions
5.
to install the drivers. When the controller is added, you'll see its name
listed in the Network adapters list. If you've installed multiple PRO/
100+ adapters, all are configured at this time.
Select the controller and click Properties to run PROSet and view the
6.
controller configuration. Controller hardware diagnostics are available
only when the drivers aren't loaded (before you restart your
computer). Driver diagnostics are available when the drivers are
loaded.
PROSet is an enhanced utility that you can use to easily configure and
test your ethernet controller in Windows NT. PROSet also displays the
computer resources that were assigned to each adapter installed.
Click OK in the main PROSet window to return to Windows NT.
7.
8. The controller now appears as the 82558-based 10/100 Ethernet
Adapter on the list in the Network window. Click Close to finish.
Restart Windows NT when prompted.
9.