If you need service...
In the event your KitchenAid appliance should
ever need service, call the dealer from whom
you purchased the appliance or a KitchenAid-
authorized service company. A KitchenAid-
authorized service company is listed in the
Yellow Pages of your telephone directory under
and Repair." You can also obtain the service
company's name and telephone number by
dialing, free within the continental
States, the KitchenAid Consumer Assistance
230. A special
operator will tell you the name and number of
your nearest KitchenAid-authorized
Maintain the quality built into your KitchenAid
Part No. 3395306 Rev. D
If dryer does not
If dryer will not operate, check to be sure that:
A. Power supply cord is connected.
B. The house fuse has not blown or
circuit breaker has not tripped.
C. Door is closed.
D. Controls are set in a running or "ON" position.
E. Start button has been pushed firmly.
F. Gas supply line shutoff valve is open.
When moving the dryer...
Disconnect the power supply cord and tape
securely to dryer.
Shut off the gas supply valve controls in the
gas supply line.
Disconnect gas pipe fittings from dryer and cap
the gas supply line.
Tape the drum to the front panel. Tape the
dyer door, lint screen lid and end of dyer gas
Adjust leveling legs all the way in.
Before installing your dyer in your new home,
check with your gas supplier or dealer to see
that your dyer is equipped with the correct
burner for the particular type of gas in your new
home. Burner information may be found on the
plate in the door well of the dyer.
Prepared by KitchenAid, St. Joseph, Michigan
If you need
The KitchenAid Consumer Assistance Center
will answer any questions about operating or
maintaining your dyer not covered in the
and Use and Care
Guide. The KitchenAid Consumer Assistance
Center is open 24 hours a day, 7 days a week.
Just dial 1-800-422-l 230 - the call is free.
When you call, you will need the dyer model
number and serial number. Both numbers can
be found on the serial/rating
plate located on
the door well of the dyer.
Plinted on recycled paper.
10% post consumer waste/
Printed in U.S.A.