Pace TDC770D Operator's Manual page 28

MAKING USER SETTINGS (cont.)
Changing the TV Display Capability
If you have not already done so, put your set-top into User Settings mode, as described on page 23.
Press the U or D button until the front panel shows "reS" (short for resolution). On the PACE USER SETTINGS
menu, TV Display Capability is highlighted when "reS" is on the front panel.
The flow diagram on page 27 shows how you use the arrow and select buttons on your set-top' s front panel to
change the display and make the settings. See also the instructions below. The available resolutions are: 1080i,
720p, 480p, and 480i. (See pages 25 and 27 for more information about these.)
1. To change the TV Display Capability, press the R button when you see "reS" on the front panel.
The front panel shows the TV display capability that was last selected, so it could show 480i, 480P, 720P, or
1080i (this final setting is displayed as 1080). The TV Display Capability menu, shown right, appears on your
TV screen.
2. Press the U or D button to highlight each resolution in turn on the menu and, for each one, press the select
button if you wish to change the setting (the setting changes between "YES" and "NO" each time you press
select).
If, at any stage in this process, the menu disappears from the screen, immediately press the
select button to restore the menu.
3 When you are satisfied that all the TV resolutions are correct, press the L button. The front panel shows "reS"
again and the PACE USER SETTINGS menu reappears.
To continue making the settings, see page 28.
26
TDC770D
TDC770D
IR RECEIVE MESSAGE
HDTV BYPASS
IR RECEIVE MESSAGE
HDTV BYPASS
If the highlighted resolution is currently
set, the MESSAGE light is lighted and
YES is on the menu
TV Display Capability
1080i : YES
720p : NO
480p : YES
480i : YES