Pace TDC770D Operator's Manual page 11

REAR PANEL (cont.)
CABLE IN
Connect the cable service here.
TO TV Connect to the RF/antenna input on your TV or
VCR (optional).
S-VIDEO Connect to the S-video input (if present) on your
VCR or TV.
VIDEO OUT Connect to the composite video input on your VCR
(or a standard TV).
COMPONENT If your HDTV does not have an HDMI
VIDEO
connect your HDTV here.
AUDIO OUT Connect to the L and R audio inputs on your
stereo TV, stereo VCR, or optional stereo amplifier.
DIGITAL AUDIO Connect to the electrical digital audio input on
OUT
optional digital audio equipment, such as an audio
decoder or home theater receiver.
OPTICAL AUDIO Connect to the optical digital audio input on
OUT
optional digital audio equipment.
HDMI
(High Definition
Multimedia
Interface)
IR RECEIVE
IR TRANSMIT
SATA
connector,
TM
USB
(Universal Serial
Bus)
ETHERNET
TV PASS MODULE
POWER OUTLET
(for TV only)
POWER INPUT
If your HDTV has an HDMI connector, connect
it here for a digital audio/video connection
(instead of using the AUDIO and three analog
COMPONENT VIDEO connectors).
Connect to an optional remote "eye".
Connect to an optional VCR controller (future use).
Connect to an optional external hard disk
(if enabled by your cable service-provider).
Connect to compatible optional equipment that
supports a USB 2.0 interface (future use).
For service use only.
Connect a TV pass® module, if required.
Connect your TV's power cord here to provide AC
power to your TV.
Connect your set-top's power cord here.
Make this connection last of all.
9