Operating External Components; Setting The Manufacturer's Code - JVC TH-D51 Instructions Manual

Operating external components

Set the remote control mode before
operation.
For TV
For STB
For VCR
Preparation
Make the audio/video input setting
before operation. (

Setting the manufacturer's code

Before operating external components from the remote
control, set the manufacturer's code.
1
Set the remote control mode (see above).
2
Press and hold
until the setting is finished.
For TV For STB
«Hold
3
4
Enter the manufacturer's code.
See "Manufacturer's code list" for the
manufacturer's code. (
5
Release .
If there is more than one code listed
for the corresponding brand, try each one until you
enter the correct one.
Set the codes after replacing batteries of the remote
control.
29
13)
for the target component
For VCR
«Hold
30)
Operating external components
Set the remote control mode before operating each
external component (see the left column).
Operating the TV
TV Turns the power on and off
TV VOL +/– Adjusts the volume
TV/VIDEO Selects the input mode (either
TV or VIDEO)
CH +/– Changes the channels
1-10, 0, h 10
Selects the channels
(100+)
TV RETURN Alternates between the
previously selected channel
and the current channel
Operating the STB
Turns the power on and off
VCR/STB
CH +/– Changes the channels
1-10, 0, h 10
Selects the channels
(100+)
RETURN Alternates between the
previously selected channel
and the current channel
Operating the VCR
VCR/STB Turns the power on and off
3 (play button) Starts playback
7 Stops playback
8 Pauses
y Fast-forwards the tape
1 Rewinds the tape
REC Press this button together with 3
(play button) to start recording or
together with 8 to enter recording-
pause.
CH +/– Changes the TV channels
0 - 9 Selects the TV channels