TYAN Thunder n4250QE-S4985G3NR-E Manual page 39

3.3.1.1 ECC Options Sub-Menu
Main Advanced
ECC Options Sub Menu
ECC Mode
ECC Error Checking
ECC Error Log
DCache ECC Scrub Control
L2 ECC Scrub Control
DRAM ECC Scrub Control
ECC Scrub Redirection
↑↓
F1 Help
← →
Esc Exit
ECC Mode
Set the level of ECC protection. If User is selected, individual ECC options may
be changed. Other options besides Disabled serve as presets. For super
mode, all of memory is scrubbed every 8 hours.
Disabled / Basic / Good / Super / Max / User
ECC Error Checking
Enable the DRAM controller to read/write ECC check-bits on the DIMMs and it
allows the north bridge to check and correct ECC errors on the DRAM bus
during normal CPU or bus master read requests.
Enabled / Disabled
ECC Error Log
Enable the MCA to log or report ECC errors on the DRAM bus.
NOTE: The MCA must still be programmed according to the desired MCE
outcome.
Enabled / Disabled
DCare ECC Scrub Control
Set the rate of background scrubbing for the DCache.
Enabled / Disabled
PhoenixBIOS Setup Utility
Memory Security
Select Item -/+
Select Menu Enter
Boot
Item Specific Help
[Disabled]
[Disabled]
[Disabled]
[Disabled]
[Disabled]
[Disabled]
[Disabled]
Change Values
u Sub-Menu
Select
39
Power Exit
F9 Setup Defaults
F10 Previous Values