Launching The Ezswitchsetup Wizard - Brocade Communications Systems 300 Administrator's Manual

2
Installing and running the EZSwitchSetup wizard

Launching the EZSwitchSetup wizard

1. Perform the following, depending on your operating system:
6
FIGURE 3
EZSwitchSetup Installer
On Windows, EZSwitchSetup starts automatically after it is installed. If it does not, see
"Launching the EZSwitchSetup wizard"
On Linux, follow the procedure
•
On Windows: EZSwitchSetup starts automatically after it is installed. If it does not, then
from the Start menu, select Programs > EZSwitchSetup > EZSwitchSetup
•
On Linux: EZSwitchSetup does not start automatically, so you have to start it manually.
NOTE
The Linux installation requires root access.
The EZSwitchSetup wizard starts, as shown in
to launch the wizard manually.
"Launching the EZSwitchSetup wizard"
Figure 4.
to launch the wizard.
EZSwitchSetup Administrator's Guide
53-1002157-01