Rear View - IBM xSeries 206 User Manual

Rear view

The following illustration shows the connectors on the rear of the server.
Power-cord connector
Mouse connector
Keyboard connector
Parallel connector
Serial 1 connector
Serial 2 connector
USB 1 connector
USB 2 connector
Ethernet connector
Video connector
If you have an optional Remote Supervisor Adapter II (systems-management
adapter) installed in PCI-X slot 2, your server has additional connectors and LEDs.
See the Option Installation Guide for more information about these connectors and
LEDs. In addition, if you install the optional Remote Supervisor Adapter II, you must
disconnect the video cable from the system board and connect it to the optional
Remote Supervisor Adapter II.
Power cord
Mouse
Keyboard
Parallel
Serial 1
Video
USB 1
USB 2
Ethernet
Serial 2
Connect the power cord to this connector.
Connect a mouse or other PS/2
Connect a PS/2 keyboard to this connector.
Connect a parallel device to this connector.
Connect a 9-pin serial device to this connector.
Connect a 9-pin serial device to this connector.
Connect a USB device to this connector.
Connect a USB device to this connector.
Use this connector to connect the server to a network.
Connect a monitor to this connector.
®
device to this connector.
Chapter 1. Introducing the xSeries 206 Type 8482 server
11