Standard Setup / Cable Connections; Operating The Tour Reverb; Selecting Channels - Hughes & Kettner Tour Reverb Manual

FX LOOP: Determines the mix of the preamp signal and the signal
generated by the connected effects device. 0 = dry (preamp
signal only), 10 = wet (effects signal only).
REVERB: Controls the intensity of the on-board reverb effect. The
reverb level is automatically adjusted for each of the three
channels when you activate it.
MASTER VOL: Controls the overall output of the TOUR REVERB. The
level of the LINE OUT signal is not influenced by this knob.
MAINS: AC power switch of the TOUR REVERB.
REAR PA N E L
MAINS SOCKET: Connect the included Euro-norm power mains
cable to this socket. Before you plug the amp into
a wall outlet, ensure your local mains voltage matches the speci-
fication indicated on the back of the amp.
HEADPHONES: Connect headphones to this jack. The internal
speaker is automatically disconnected when you insert a plug
into this jack.
SPEAKER OUT:
Combo: The Tour Reverb Combo is equipped with a serial louds-
peaker output. When you connect an external cabinet, the
overall impedance increases, lowering the output of the power
amp somewhat. However, with a connected cabinet your rig
has a lot more speaker surface area,
which pretty much compensates for this effect.
Head: The Head version of the Tour Reverb ships with parallel
Speaker Outs. Please make sure that connected cabinets do not
have an overall impedance lower than the 4-ohm rating of
these outputs! You can connect any single cabinet with a rating
of at least 4 ohms, or you can connect two cabinets if each one
is rated at 8 ohms or higher.
LINE OUT: Use this jack to send signals to a mixing console, D.I.
box or additional power amp to drive additional cabinets.
FX SEND: Connect this output to the input of your effects device.
FX RETURN: Connect the output of your effects device to this
jack.
REV/FX. FOOTSWITCH: Stereo jack designed to take a dual-func-
tion footswitch (the Hughes & Kettner FS-2 will do nicely) to
switch the FX LOOP and integrated REVERB on and off via the
usual tap dance moves.
CHANNEL FOOTSWITCH: Stereo jack designed to take a dual-fun-
ction footswitch for switching back and forth between the
CLEAN, CRUNCH and LEAD channels.

3.0 STANDARD SETUP / CABLE CONNECTIONS

4.0 OPERATING THE TOUR REVERB

4.1 SELECTING CHANNELS

You can activate the three channels of the TOUR REVERB via
the front panel CHANNEL SELECT buttons or an optional foots-
witch.
If you use a footswitch, make sure that the front panel CHAN-
NEL SELECT and CRUNCH/LEAD buttons are both in the OFF
position (not depressed). In other words, be sure to select the
HOME