Table of Contents
Advertisement
Ch 3: Installing Optional Devices
Fix the internal DAT onto the device bracket with four mounting screws (attached to each internal DAT).
6.
Install the device bracket onto the system equipment, then fix it with two mounting screws. While installing,
7.
insert the claw of the device bracket into the guide hole on the system equipment.
Use extreme care to protect internal hard disks from shock (hitting or falling on hard material).
Being precision devices, internal hard disks are very susceptible to shock.
The next step is connecting cables. See "Connecting Cables" on page 78.
Installing an Internal DAT Changer (Optional)
This section explains how to install an internal DAT changer onto extended storage bays. The height of the internal
DAT changer is approximately twice the height of one extended storage bay, so use extended storage bays 8 and 9.
72
Guide hole
Claw
Power connector
SCSI connector
Short bar
Hitachi PC VisionBase 8450H/R Server
Advertisement
Table of Contents
