Table of Contents
Advertisement
Message:
Boot ROM will not install: Incompatible SDMS 3.X version
Explanation:
BIOS version 3.XX.XX had already been loaded before version 4.XX.XXwas loaded.
Update it to version 4.XX.XX.
Message:
ERROR! The PCI System BIOS is NOT present
Explanation:
There is no PCI system BIOS. The system has a problem in a portion other than this board.
Message:
INVALID serial EEPROM dataÅCserial EEPROM was ....
Explanation:
Incorrect data has been detected within NVRAM. The data is rewritten to the initial value by
BIOS.
Message:
ERROR! This adapter is malfunctioning
Explanation:
The board operated abnormally. The board might be faulty.
Message:
Bus Master ERROR
Explanation:
The controller chip on the board operated abnormally. The controller chip might be faulty.
Message:
Warning! IO address not enabled
Explanation:
The PCI system BIOS has not assigned any I/O address to the board. The system has a
problem in a portion other than this board.
Message:
Failed to add deviceÅCtoo many devices
Explanation:
Too many SCSI devices are to be connected. Up to 24 SCSI devices can be connected.
Message:
Calculated number of heads is too large!
Explanation:
The header size of the drive's boot partition block is incorrect.
Message:
<CdGeometry: No 55AA at end of MBR!>
Explanation:
The boot partition block of the drive has an incorrect signature.
Message:
<CdGeometry: SystemType is Zero!>
Explanation:
The boot partition of the drive has been destroyed.
Message:
<CdGeometry: End_Cyl is Zero!>
Explanation:
The boot partition of the drive has been destroyed.
Message:
<CdGeometry: cylHead not divisible by End_Cyl>
Explanation:
The boot partition of the drive has been destroyed.
Message:
Failed to add deviceÅCtoo many devices!
Explanation:
Too many devices are to be controlled by INT13.
Message:
ERROR in serial EEPROM data, serial EEPROM was...
Explanation:
Data in EEPROM has been destroyed.
Hitachi PC VisionBase 8450H/R Server
Ch 4: System Environment Settings
111
Advertisement
Table of Contents
