Motorola 68230 - Vanguard 300 DSU/CSU Operator's Manual page 54

Example of Removing the Front Panel
Figure 4-1 shows how to remove the front panel.
Example of Releasing Locking Clips
Figure 4-2 shows how to release the plastic locking clips at the bottom of the
standalone unit.
Example of How to Release Snap Hinges
Figure 4-3 shows how to release the snap hinges located at the bottom of the unit.
Example of Removing Top Cover
Figure 4-4 shows how to properly remove the top cover after you unlock releases
and snap hinges on the unit.
Strapping the Ethernet Interface on a Vanguard 300
Introduction
This section describes how to set the strapping for the Ethernet interface on a
Vanguard 300. Ethernet strapping is located under the daughtercard for the
Vanguard 300 unit. The default setting for Ethernet strapping is 10BaseT.
This information is only applicable to the Vanguard 300, as the Vanguard 305
does not have an Ethernet interface.
Figure 4-1. Removing the Front Panel
Figure 4-2. Releasing Plastic Locking Clips
Figure 4-3. Releasing the Snap Hinges
Figure 4-4. Removing Top Cover