Motorola 68230 - Vanguard 300 DSU/CSU Operator's Manual page 28

Overview
This chapter contains sample applications you can use as a reference to configure
your own Vanguard 300/305 applications.
The following configurations show critical parameters only. You should be
familiar with the 6500 Series configuration procedures before you configure a
Vanguard 300/305. Refer to the 6500 Series Introduction Manualand the 6500
Series Configuration and Administration Manual for more information.
CTP Menu Navigation
The following convention shows you how to navigate through CTP menus when
configuring parameters for the Vanguard using the sample procedures in this
section.
When you see...
...select Configure Router -> Configure
IP -> Interfaces -> IP Interfaces
Configuration Table.
IPX Over Frame Relay
Introduction
The example shown in Figure 3-1 shows IPX running over Frame Relay using
RFC1294.
What You Need to Configure
The following table lists the items that you need to configure for nodes 100 and
200.
For Node 100...
LAN Connection Table
IPX Parameters and Interfaces
LLC-SDLC FR Station Table
Port Records
Route Selection Table
PVC Table
FRI Stations
Interfaces
Configuring the Vanguard 300/305
This means...
...select these options, records or tables
from the CTP menus in the order they
appear in the documented procedure.
For Node 200...
LAN Connection Table
IPX Parameters and Interfaces
Port records
Route Selection Table
PVC Table
Mnemonic Table
FRI Stations
XDLC Port Stations
Interfaces