Resetting The Standard Product Default Settings: All Application Work Groups - Honeywell 2020-5 User Manual

The Menu Commands
each of the commands (indicated by an asterisk (*) on the programming pages).
Note: Scanning this bar code also causes both the image scanner and the base
to perform a reset and become unlinked. Refer to
Scanner to Base"
Note: If your image scanner is in multiple image scanner mode and you scan
either the current or all application group default bar code, you will hear
up to 30 seconds of beeping while all image scanners are re-linked from
the base and the settings are defaulted to * settings. The default interface
is keyboard wedge and the default image scanner mode is single image
scanner locked link mode.
Resetting the Standard Product Default Settings:
All Application Work Groups
The following bar code defaults all of the work groups to the factory settings.
The Menu Commands
settings for each of the commands (indicated by an asterisk (*) on the program-
ming pages).
starting on page 10-6
on page 1-5 for additional information.
Standard Product Default Settings:
Current Application Group
Standard Product Default Settings:
All Application Groups
starting on page 10-6
list the factory default settings for
"Linking Image
list the standard product default
10 - 5