Changing Image Scanner Name - Via Bar Codes - Honeywell 2020-5 User Manual

Changing Image Scanner Name - via Bar codes

If you wanted to set up your image scanners with names 0001-0007, you may
scan the bar codes below. Scan the Reset bar code after each name change
and wait for the image scanner to re-link to the base before scanning the next
bar code to name the next image scanner.
Alternatively, you may change the name with a bar code command if you cannot
send serial commands to the base. One way to do this is to scan the bar code
below and scan a number for the image scanner name. For example, if you had
7 image scanners to one base, scan the bar code below with the first image
scanner, scan the 1 bar code on the
of this manual and scan Save. Then scan the Reset bar code and wait for the
image scanner to re-link to the base before scanning the next bar code. Repeat
that process for image scanner number 2, 3, 4 etc.
If you want to assign an alphabetic name to the image scanner, create a Code
128 bar code containing "~BT_NAM name ." followed by a FNC3 character (hexi-
decimal 83), where name is the new image scanner name. Scan the Reset bar
code (page 1-8 or on the
ual). You may use Barcode Builder, which is included with Quick*View. You
may download Quick*View from the Honeywell International Inc. website: at
www.honeywellaidc.com
1 - 8
0001
0003
0005
0007
Programming Chart
Image Scanner Name
Programming Chart
.
0002 0002
0004
0006
Reset
inside the back cover
inside the back cover of this man-