Using The Zoom On-Screen Display - IBM P72 Operating Instructions Manual

4
Press the >?// buttons to adjust the settings.
For Press
ROTATION / . . . to rotate the picture clockwise
? . . . to rotate the picture counterclockwise
PINCUSHION / . . . to expand the picture sides
? . . . to contract the picture sides
/ . . . to move the picture sides to the right
PIN BALANCE
? . . . to move the picture sides to the left
/ . . . to increase the picture width at the
KEYSTONE
top
? . . . to decrease the picture width at the
top
/ . . . to move the top of the picture to
KEY BALANCE
the right
? . . . to move the top of the picture to
the left
The OSD automatically disappears after about 30 seconds.
To close the OSD, press the
To reset, press the ? (reset) button while the OSD is on.
The selected item is reset to the factory setting.
button again.
Getting Started
Customizing Your Monitor
Using the ZOOM On-screen
Display
The ZOOM settings allow you to enlarge or reduce the
picture.
Once the setting is adjusted, it will be stored in memory for
the current input signal.
1
Press the button.
The MENU OSD appears.
2
Press the ¨./> and >?// buttons to select "
ZOOM," and press the
The ZOOM OSD appears.
3
Press the >?//buttons to adjust the picture zoom.
/ . . . to enlarge the picture
? . . . to reduce the picture
The OSD automatically disappears after about 30 seconds.
To close the OSD, press the
To reset, press the ? (reset) button while the OSD is on.
Note
The picture zoom adjustment will stop as soon as either the
horizontal or vertical size reaches its maximum or minimum value.
button again.
ZOOM
H 26
V 73
button again.
7
EN
F
ES
C