Using The Option On-Screen Display - IBM P72 Operating Instructions Manual

Customizing Your Monitor
4
Press the >?// buttons to adjust the settings.
For Press
/ . . . to shift red shadows to the right
and blue shadows to the left
H CONVERGENCE
? . . . to shift red shadows to the left
and blue shadows to the right
/ . . . to shift red shadows up and blue
shadows down
V CONVERGENCE
? . . . to shift red shadows down and
blue shadows up
/ . . . to turn CANCEL MOIRE "ON"
CANCEL MOIRE
? . . . to turn CANCEL MOIRE "OFF"
/ or ? . . . to adjust the screen until the
MOIRE ADJUST
Note
The picture may become fuzzy when CANCEL MOIRE is set to
"ON."
The OSD automatically disappears after about 30 seconds.
To close the OSD, press the
To reset, press the ? (reset) button while the OSD is on.
The selected item is reset to the factory setting.
10
OFF ON
ON
OFF
moire is at a minimum
50
button again.
Using the OPTION On-screen
Display
The OPTION OSD allows you to manually degauss the
screen and adjust the OSD position. It also allows you to
lock the controls.
Degaussing the screen
The monitor screen is automatically degaussed
(demagnetized) when the power is turned on.
You can also manually degauss the monitor.
1
Press the button.
The MENU OSD appears.
2
Press the ¨./> and >?// buttons to select "
OPTION," and press the
The OPTION OSD appears.
3
Press the ¨./> buttons to select "
DEGAUSS)."
4
Press the > / button.
The screen is degaussed for about 5 seconds.
If you need to degauss the screen a second time, wait for at
least 20 minutes before repeating the steps above.
The OPTION OSD automatically disappears after about 30
seconds.
To close the OSD, press the
button again.
OPTION
ON
MANUAL DEGAUSS
(MANUAL
button again.