Screen Display - IBM 6550-23N Service Manual

Customizing Your Monitor
Using the SIZE/CENTER On-

screen Display

The SIZE/CENTER settings allow you to adjust the
picture's size, centering, or zoom.
Once the setting is adjusted, it will be stored in memory for
the current input signal.
1
Press the button.
The MENU OSD appears.
2
Press the ./> buttons to select " SIZE/CENTER"
and press the button again.
The SIZE/CENTER OSD appears.
S I ZE / CENTER
2 6
3
Press the ./> buttons to select the item you want to
adjust.
Select To
(Horizontal Centering) adjust the horizontal centering of the
picture
(Vertical Centering) adjust the vertical centering of the
picture
(Horizontal Sizing)
adjust the horizontal size of the
picture
(Vertical Sizing) adjust the vertical size of the picture
(Zoom)
enlarge or reduce the picture
6
4
Press the ?// buttons to adjust the settings.
Select To
/ . . . to move the picture right
(Horizontal Centering)
? . . . to move the picture left
(Vertical Centering) / . . . to move the picture up
? . . . to move the picture down
/ . . . to increase picture width
(Horizontal Sizing)
? . . . to decrease picture width
(Vertical Sizing) / . . . to increase picture height
? . . . to decrease picture height
(Zoom) / . . . to enlarge the picture
? . . . to reduce the picture
Press the button once to return to the MENU OSD, and
twice to return to normal viewing. If no buttons are pressed,
the OSD closes automatically after about 30 seconds.
To reset, press the ? (reset) button while the OSD is on.
The selected item is reset to the factory setting.
Notes
The (Zoom) adjustment stops when the horizontal or vertical
size reaches its maximum or minimum value. The horizontal
adjustment value is not displayed in the menu.
Using the GEOMETRY On-
screen Display
The GEOMETRY settings allow you to adjust the shape and
orientation of the picture.
Once the (Rotation) is adjusted, it will be stored in
memory for all input signals received. All other adjustments
will be stored in memory for the current input signal.
1
Press the button.
The MENU OSD appears.
2
Press the ./> buttons to select " GEOMETRY" and
press the button again.
The GEOMETRY OSD appears.
GEOMETRY
2 6
3
Press the ./> buttons to select the item you want
to adjust.
Select To
(Rotation) adjust the picture rotation
(Pincushion) adjust the picture sides
(Pin Balance) adjust the picture side balance
(Keystone) adjust the picture width
(Key Balance) adjust the picture shape balance
Getting Started
Customizing Your Monitor
4
Press the ?// buttons to adjust the settings.
For Press
(Rotation) / . . . to rotate the picture clockwise
? . . . to rotate the picture counterclockwise
(Pincushion) / . . . to expand the picture sides
? . . . to contract the picture sides
(Pin Balance) / . . . to move the picture sides to the right
? . . . to move the picture sides to the left
(Keystone) / . . . to increase the picture width at the
top
? . . . to decrease the picture width at the
top
(Key Balance)
/ . . . to move the top of the picture to
the right
? . . . to move the top of the picture to
the left
Press the button once to return to the MENU OSD, and
twice to return to normal viewing. If no buttons are pressed,
the OSD closes automatically after about 30 seconds.
To reset, press the ? (reset) button while the OSD is on.
The selected item is reset to the factory setting.
7
EN
F
ES
C