Adjusting Contrast, Panel Dimmer; Selecting A Display - Furuno DS-80 Operator's Manual

1.3 Adjusting Contrast, Panel
Dimmer
1.3.1 Contrast
1. Press the [*] key to open the contrast
adjustment dialog box.
CONTRAST (0~63)
2. Press the Omnipad at
the contrast. The setting range is 0 to 63
and the default setting is 48.
3. Press the [ENT] key.
Note: The contrast is automatically set to
default (48) when the power is turned on.
1.3.2 Panel dimmer
1. Press the [DIM] key to show the dimmer
adjustment dialog box.
DIMMER (1~8)
2. Press the Omnipad at
the dimmer. The setting range is 1 to 8
and the default setting is 4.
3. Press the [ENT] key to conclude.
Note: The [DIM] key is inoperative when
dimmer is controlled externally.
41
EXIT: [ENT]
or to adjust
7
EXIT: [ENT]
or to adjust
1.4

Selecting a Display

Press the [DISP] key to select display
desired. Each time the key is pressed the
display shows speed and distance run or
speed alone as below.
Direction
: Fore
: Aft
SPEED
DISTANCE
SPEED
1 0 . 0
Arrow indicates direction:
fore; , aft.
The distance run indication shows the
total distance run in forward speed only.
The distance run is backed up when the
power is turned off.
Note: Speed error may occur in rough seas
because of air bubbles, etc.
When speed error occurs, the speed
indication freezes, and "KT" is highlighted
and blinks. If speed error continues more
than 30 seconds, the speed indication
changes to **.*.
6
STW
10.0
Speed
kt
12.50
Distance
Run
nm
[DISP] key
to switch
STW
kt
indicates