Chicago Electric ITEM 69684 Owner's Manual & Safety Instructions page 13

General Operating Instructions
DANGER!
MITER SAWS CAN QUICKLY AMPUTATE FINGERS IF MISUSED.
Keep hands well clear of cutting area.
1. Unlock the Head Lock-down, see page 9.
2. Make sure all adjustment knobs are tight (Miter Knob,
Bevel Lock Knob, Fence and Table Extension Knobs).
3. Blow any sawdust or debris away from the Fence.
Place the work material against the Fence.
4. Align the marked location of the cut on
the work material with the saw blade.
Note: To prevent your workpiece from being cut too short,
align the edge of the blade with your measured mark,
keeping the rest of the blade on the waste side of the cut.
5. Hold the work material in place using the Clamp.
Ensure that the work material is level and supported
securely, use saw horses or supports if necessary.
6. Grip the Saw Handle, press one of the Trigger
Locks with your thumb, and squeeze the
Trigger to start the Saw and the laser guide.
Note: If the laser guide line does not line up
with the cut line, release trigger and reposition
workpiece before making the cut.
Item 69684 For technical questions, please call 1-800-444-3353.
7.
8. Press down lightly to cut the material.
With narrow material,
press straight down "chopping" the material.
With wide material,
move the Blade across the material while cutting.
Do not bear down on the material, use
light downward pressure. If the material
binds the blade, release the trigger.
9. When the cut is completed, raise the blade
assembly, release the trigger, wait for the
Blade to stop turning, release the Clamp and
remove the work material from the saw.
10. To prevent accidents, turn off the tool and
disconnect its power supply after use. Clean, then
store the tool indoors out of children's reach.
Page 13