Canon LEGRIA HFM406 Instruction Manual page 161

Built-in memory is full
- The built-in memory is full ("f End" appears on the screen). Delete some recordings
(0 54, 112) to free some space. Alternatively, save your recordings (0 123) and initialize
the built-in memory (0 38).
Cannot access the built-in memory
- There is a problem with the built-in memory. Contact a Canon Service Center.
Cannot communicate with the battery pack. Continue using this battery pack?
- You attached a battery pack that is not recommended by Canon for use with this camcorder.
- If you are using a battery pack recommended by Canon for use with this camcorder, there
may be a problem with the camcorder or battery pack. Consult a Canon Service Center.
Cannot convert
- Cannot access the memory card. Check the memory card and make sure it is inserted cor-
rectly.
- You inserted a MultiMedia Card (MMC) into the camcorder. Use a recommended memory card
(0 33).
- There was an error creating the file name. Set 8
initialize the memory card (0 38) or delete all the photos (0 112) and converted SD mov-
ies (0 54).
Cannot copy
- The total size of the scenes you selected to copy exceeds the available space on the memory
card. Delete some recordings on the memory card (0 54, 112) or reduce the number of
scenes to copy.
- The memory card already contains the maximum number of scenes (3,999 scenes). Delete
some scenes (0 54) to free some space.
- The gallery already contains the maximum number of stories (98 stories in any one given
memory). Delete some stories (0 56) to free some space.
Cannot divide the scene. Initialize only using the camcorder.
- Use the supplied software VideoBrowser to save the scene and divide it on the computer.
Cannot enter standby mode now
- The camcorder cannot enter standby mode if the remaining battery charge is too low. Charge
or replace the battery pack (0 19).
Cannot load canvas
- The canvas file that was saved on the memory is corrupted.
- Canvas data cannot be read from canvas files created using other devices and then trans-
ferred to a memory card connected to the computer.
Cannot play back
- There is a problem with the memory. If this message appears often without apparent reason,
contact a Canon Service Center.
8
[Photo Numbering] to [Reset] and
Additional Information
161