3.1.9 Removing the parts on the main board(See Figure 15
and Figure 16)
• Prior to the following procedure, main board should be re-
moved.
*Removing the hard disc drive.
(1) Pull out the flexible wire from the connector
the main board.
(2) Remove two screws O that are attached to the hard disc
drive.
*Removing the built in memory card and wireless LAN card.
(1) Release the catches on both sides of the memory card i.
Pull out the memory card as it pops up.
(2) Release the catches on both sides of the wireless LAN
card j and remove the wireless LAN card as the same way
as removing the memory card .
1-8 (No.XE003)
CON25
on
Main board
Memory card
O
Hard disc drive
Fig.15
Wireless LAN card
i
i
O
Main board
Fig.16
CON25
j
j