Disassembly - JVC MP-XV941DE Service Manual

3.1 Disassembly procedure
3.1.1 Removing the DIMM cover(See Figure 1)
(1) Remove three screws A from the DIMM cover on the bot-
tom of the main unit.
(2) Remove the DIMM cover by lifting it up from the gap a.
3.1.2 Removing the DVD drive unit(See Figure 2)
• Prior to the following procedure, DIMM cover should be re-
moved.
(1) Remove two screws B, which are attached to the DVD
drive unit, from the bottom of the main unit.
(2) Push part b in the direction indicated by the arrow, then pull
out the DVD drive unit by sliding outward.
3.1.3 Removing the fitting(See Figure 2, Figure 3)
• Prior to the following procedure, DVD drive unit should be
removed.
(1) Eject the tray by inserting a piece of fine wire into the small
hole c.
(2) Disengage three tabs d, and then disengage one hook e.
* Pay special attention not to damage either the tabs or
the hooks.
SECTION 3

DISASSEMBLY

A
Hook e
Gap a
A
DIMM Cover
Fig.1
Part b B
DVD Drive unit
B
Fig.2
DVD Drive unit
Tab d Tab d Fitting
Fig.3
A
Hole c
Tab d
(No.XE003)1-3