JVC MP-XV941DE Service Manual page 5

3.1.5 Removing the hinge cover(See Figure 7 ,Figure 8, Figure 9)
(1) Remove one screw C and two screws B from the hinge
cover.
C :short D :long
(2) Disconnect one card wire from the connector
main board.
(3) Remove one screw E from the bottom of the main unit.
(4) Leave the LCD panel open. Release four tabs g on the
hinge cover by slowly inserting a single-slotted or flat
screwdriver into the slot of the battery terminal.
*Please make sure not to damage either the hinge cov-
er or the bottom case when releasing the tabs.
(5) Slowly remove the hinge cover in the direction indicted by
the arrow.
CON5 on the
Hinge cover
Hinge cover
D
C D
Fig.7
E
Fig.8
Tab g Tab g
Bottom case
Battery terminal LCD Panel assembly
Fig.9
CON5
Tab g
Tab g
(No.XE003)1-5