Wiring - Furuno FMD-8010 Operator's Manual

Overhead mounting
1) Referring to Figure 3-2, change the loca-
tion of the fixing plate, mounting base, bot-
tom plate and cover to mount the unit on
the overhead.
Fixing
plate
M8 x 40 bolt
(2 pcs.)
Mounting
base
Figure 3-2 Display unit overhead mounting

3.2 Wiring

At least two cables are terminated at the dis-
play unit: the signal cable and the power cable.
The signal cable, which is available in lengths
of 5 meters, 10 meters or 15 meters, comes
prefitted with a connector for connection to
the display unit.
Proper grounding of cables cannot be stressed
enough; be sure to ground the shield of cables
by the cable clamp.
3 – 2
Fabricating the power cable CVV-S
8 x 2C (optional supply)
1) Remove the vinyl sheath by 40 mm.
2) Unravel the braided shield to expose the
ø9 coach screws
3) Remove insulation of cores by about 10
or M10 bolts
4) Fix crimp-on lugs to the cores and braided
Hex screw
Bottom
plate
M3 x 6 screw
(4 pcs.)
Laying cables inside the display
unit
Cover
cores.
mm.
shield.
CVV-S 8X2C
(a)
Approx. 60 mm
(b)
(c)
Clamp here
(d)
Taping
Figure 3-3 How to fabricate the power
cable (CVV-S 8 x 2C)
Figure 3-4 Display unit, rear
view, cover removed
10mm
25 mm
SPU Board
Cable
Cable
clamping
clamp
plate