Table of Contents
Advertisement
Reconnecting to the web-based manager
Using the command line interface
40
4
After you set the last digit of the default gateway, press Enter.
5
Press Esc to return to the Main Menu.
You have now completed the initial configuration of the FortiGate unit and you can
proceed to
"Next steps" on page
As an alternative to the web-based manager or setup wizard you can begin the initial
configuration of the FortiGate unit using the command line interface (CLI). To connect
to the CLI, see
"Connecting to the command line interface (CLI)" on page
information that you gathered in
procedures.
To change to Transparent mode using the CLI
1
Make sure that you are logged into the CLI.
2
Switch to Transparent mode. Enter:
config system global
set opmode transparent
end
The FortiGate unit restarts. After a few seconds, the login prompt appears.
3
Type admin and press Enter.
The following prompt appears:
Welcome !
4
Confirm that the FortiGate unit has switched to Transparent mode. Enter:
get system status
The CLI displays the status of the FortiGate unit including the following line of text:
Operation mode: Transparent
To configure the management IP address
1
Make sure that you are logged into the CLI.
2
Set the management IP address and netmask to the IP address and netmask that you
recorded in
Table 8 on page
config system manageip
set ip <address_ip> <netmask>
end
43.
Table 8 on page 38
38. Enter:
01-28005-0101-20041015
Transparent mode installation
15. Use the
to complete the following
Fortinet Inc.
Advertisement
Table of Contents
