Advertisement
ProductDimensions
(74.6 mm)
burner box
depth
Cutout#imensions
14o5/8" (37,1 cm)
blower housing
depth
34t. (91.4 ¢m) long
power sopply cane
factory installed
Clearance #imensiens
[_'Jinimom distance
"",,._
to nearest cembostiNe?',,_
vertical surface
, ..
extending 18" (45_7 cra)
',
above cooktop
39" (7&2 cm) mie = 38" (75,2 cm) model
39" (91.4 cm) min - 39" (91.4 ¢m) model
when higher than 18" (45,7 cm) ---_1
See Note ** for
minimum clearances
4-
.
cm)
rJo m_et s eau
_r.rrnn-_'_
opening depth
cooktop to coootertop_
N'N_
"
1" (25,4 ram)
_;;_-_.
29-1/2" (74.9 co) = 39" (7&2 ¢m) model
35-1/2" (9&2 cm) - 39" (91 _4cm) model
cutoutwidth
Side clearance -- 6" (15.2 cm) minimum clearance between side
of cooktop and side wall is recommended for maximum
ventilation performance.
Rear clearance -- 3/4" (19.1 ram) clearance between rear edge of
cooktop and rear wall is recommended.
Motor/b!ower
clearance -- 2" (51 ram) minimum clearance
between motor and cabinet is required for proper cooling.
6" (15.2 cm) clearance is recommended for servicing access.
_ Note: 24" (51 era) rainiraura when bottom of wood or rectal cabinet is
protected by not Jessthan I/4" (5,4 rare) Narae retardant raiJJboard covered
with not less than No, 28 MSG sheet steel 0.915" (0.4 rare) stainless steel
0.024" (0.5 rata} alurainura or 0.029" (0.5 rare) copper.
30" (7&2 cm) rainiraura clearance between the top of the cooking platform
and bottom of unprotected wood or sheet metal
I
floor
11" (27,9 cm)
8" (20,3 cm)
Minimum
base cabinet
dimensions
--
30" (76.2 cm) base cabinet width
24" (61 cm) base cabinet depth
25" (63.5 cm) countertop depth
Countertop
opening dimensions
that are shown must
be used. Given dimensions are minimum clearances and
provide required 0" (0 cm) clearance.
New installations -- Follow minimum dimensions given.
Replacement installation
-- Be sure that front edge of
cooktop is at least 1=1/2" (38.1 mm) back from front
edge of countertop.
ff cabinet has drawers, drawers will need to be
removed and drawer fronts installed on front of cabinet.
Cutout preparation:
Decorative laminate --
Chamfer all exposed edges to
prevent chipping laminate.
Cut radius corners and file to
smooth edges and to prevent
cracking.
Advertisement
