Advertisement
For amJcooktop
modeJs
with four-
wire cabRe from the cooktop.
(These
cooktops
are
manufactured
with white
(neutra 0 power
supply
wire and
a cabinet-connected
bare ground
wire factonj=crimped
together.):
Where local codes Do Not permit
connecting
the frame-ground
conductor
to the neutrat (white)
junction box wire:
1. Disconnect
power supply.
2. Remove the junction box cover from
the junction box inside the cabinet=
3. Connect the flexible, armored cable
from the cooktop to the junction box
using a U.L.- or C.S.A.-listed conduit
connector. Tighten screws on conduit
connector.
4, Connect the two black wires together
and the two red wires together.
5, Separate the factory-crimped bare and
white cooktop cable wires.
6o Connect the two white wires together
using twist=on connectors.
7. Connect the bare ground wire from the
cooktop cable to a grounded wire in
the junction box or other grounded
connector using twist-on connector.
(See Figure 3.)
Do Not connect bare ground wire to
neutrat (white) wire in junction
box.
8, Replace the junction box cover,
Check operation
u Turnon electrical supply.
Checkthat cooktopsurface elements
heat and indicatorlights are operatingcorrectly.
E Checkthat downdraftvent operates,if
the cooktop does not operate, disconnect the
powersupply and checkthat wire connections
have been made correctly'.
You have just finished
installing your
new downdraft
cooktop. To get the
most efficient
use from your new
cooktop,
read your Use & Care Guide.
Keep Installation instructions and
Guide cmose to cooktop
for easy
reference.
Coektopremevai
if removing the eooktop is necessary
for cleaning or maintenance:
1. Disconnect electrical supply,
2. Disconnect vent system.
3. Lift cooktop out of countertop to
complete cleaning or maintenance.
After cleaning and maintenance:
1. Reinstall cooktop in cutout.
2. Check that front edge of cooktop is
parallel to front edge of countertop.
3. Connect vent system,
4. Connect electrica! supply.
[_
Check that the circuit breaker is not
tripped or the house fuse blown.
[_
Check that the power supply cord is
plugged into the outlet (120 V models).
[_See
Use and Care Guide for
troubleshooting list.
Note: Refer to Use and Care Guide for
operating and cleaning instructions.
If you need
If you have questions
about
operating,
cleaning
or maintaining
your cooktop:
[_
Refer to Use and Care Guide,
[_
Call the Customer interaction Center,
Check your Use and Care Guide for
a toll4ree number to call or call the
dealer from whom you purchased
this appliance, The dealer is listed in
the Yellow Pages of your phone
directory under "Appliances --
Household -- Major -- Service and
Repair,"
If yo.uneed
Maintain the quality built into your
cooktop
by calling an authorized
service
company.
To obtain the name and number of the
authorized service company:
[_
Contact the dealer from whom you
purchased your cooktop; or
[_
Look in the Yellow Pages of your
telephone directory under
"Appliances -- Household --
Major -- Service and Repair;" or
[_
Call the Customer interaction Center.
The toll4ree number is listed in your
Use and Care Guide=
When you call, you will need:
[_]
The cooktop model number.
[_The
cooktop serial number.
Both numbers are listed on the
model/serial rating plate located on the
underside of cooktop burner box.
Part No. 8285116
© 2002 Whirlpool
Corporation
Benton
Harbor, Michigan
49022
Printed
in U.S.A.
Advertisement
