Care & Cleaning; Table; Burners; Oven Door - Kenmore 790. 7260 Use & Care Manual

Hide thumbs Also See for 790. 7260:
Table of Contents

Advertisement

Available languages

Available languages

Care & Cleaning
Cleaning
recommendation
table
Surface
type
Recommendation
Control knobs
Painted body parts
Painted decorative
trim
Aluminum,
plastic or vinyl trim
pieces
For general
cleaning, use hot, soapy water
and a cloth. For more difficult soils and
built-up grease, apply a liquid detergent
directly onto the soil. Leave on soil for 30-
60 minutes.
Rinse with a damp cloth and dry. Do not use abrasive cleaners on any of
these materials;
they can scratch. To remove control knobs, turn to OFF position;
grasp firmly and pull straight off the shaft. To replace
knobs after cleaning, line up
the flat sides of both knob and shaft; then push knob into place.
Control panel
Before cleaning
the control
panel, turn all controls
OFF, activate
oven lockout
(on
Control key pad membrane
some models) and if needed
remove any knobs from panel. Do not use abrasive
Decorative
trim (some models)
cleaners
on any of these materials;
they can scratch.
Clean using hot, soapy water
and a dishcloth.
Be sure to squeeze excess water
from dishcloth
before
wiping
control
panel; especially
when wiping
around
the controls
area. Excess water in or
around
the controls
may cause damage
to the appliance.
When rinsing, use clean
water
and a dishcloth
and be sure to squeeze excess water
from dishcloth
before
wiping
the control
panel.
Porcelain
enamel
parts & door
Gentle
scrubbing
with a soapy no-scratch
cleaning
pad will remove most spots. Rinse
liner
(some models)
with a 1:1 solution
of clear water
and ammonia.
If necessary, cover difficult
spots
with an ammonia-soaked
paper
towel for 30 to 40 minutes. Rinse with clean water
and a damp
cloth, and then scrub with a soap-filled
no-scratch
cleaning
pad. Rinse
and wipe dry with a clean cloth. Do not allow food
spills with a high sugar or acid
content
(milk, tomatoes,
sauerkraut,
fruit juices or pie filling)
to remain
on the
surface;
they may cause a dull spot even after cleaning.
Do not clean oven door
gasket.
Oven interior
For oven interior
remove excessive spillovers
from oven cavity
bottom
before
starting
Select Clean. Clean any soils from oven frame
and door liner outside the oven door
gasket. Do not clean overn door gasket. For very important
cleaning
precautions
be
sure to read all the instructions
in the Select Clean section.
Oven racks
Remove oven racks from oven cavity
before
starting
Select Clean. Clean by using a
mild, abrasive
cleaner
following
manufacturer's
instructions.
Rinse with clean water,
dry and then replace
in oven.
Oven door
Use soap & water
to thoroughly
clean the top, sides and front of the oven door.
Rinse well. You may use a glass cleaner
on the outside glass of the oven door. Do not
immerse the door in water. Do not spray
or allow
water
or the glass cleaner to enter
the door vents. Do not use oven cleaners,
cleaning
powders
or any harsh abrasive
cleaning
materials
on the outside of the oven door.
Do not clean oven door gasket.
Cooktop surface
Do not use spray oven cleaners
on the cooktop.
See Cleaning
the cooktop
and burner
Surface burners
grates instructions
provided
in the Care & Cleaning
section.
Burner grates
Stainless Steel (some models)
Only use cleaners and polishes that are specifically
manufactured
for cleaning
stainless steel. Always
rub in direction
of metal grain to avoid damaging.
Do not use
cleaners
with
high concentrations
of chlorides
or chlorine.
Do not use harsh
scrubbing
cleaners.
Polish with a lint-free
cloth. Always
be sure to wipe excess
cleaner/polish
off from the metal surface
as bluish stains may occur during future
oven heating
that cannot
be removed.
Clean heavier soils with hot, soapy water
and
a dishcloth.
Rinse and dry using clean water
and a cloth.
2O

Advertisement

Table of Contents
loading

This manual is also suitable for:

790.7263

Table of Contents