Resetting To Factory Defaults; Cleaning The Drain Flow Control; Removing Drain Fitting To Clean Flow Control - Kenmore 625.382080 Owner's Manual

RESETTING TO FACTORY DEFAULTS
To reset the electronic controller to its factory default
for all settings (time, frequency of automatic Clean
Rinse cycles, etc.):
1. Press the SELECT button and hold it until the display
changes twice to show "SET CODE" and the flashing
model code.
2. Press the /X UP button twice to display a flashing
"SOS".
3. Press the SELECT button, and the electronic controller
will restart.
4. Set the present time, as described on page 12.
SET
CODE
dF
SET CODE
Figure 22
CLEANING THE DRAIN FLOW CONTROL
This procedure is not required if the Central Water
Whole Home Filtration System is operating normally. It
should be performed only if a problem with lack of
water flow to drain is encountered, as detailed in the
troubleshooting table on Page 19.
1. Remove the clip holding the drain fitting into the
valve (See Figure 23).
2. Remove the drain fitting from the valve
3. Clear any obstruction.
4. Reinstall the drain fitting into the valve.
5. Reinstall the clip to secure the drain fitting in the
valve.
Drain
Hose
REMOVING DRAIN FITTING TO CLEAN
FLOW CONTROL
Flow
Clip Control
Clamp
f
Drain
Fitting
j_
Figure 23
Questions? Call The Kenmore Water Line 1-800-426-9345 or visit KenmoreWater.com
21