Kenmore 407.53530 Use & Care Manual page 14

Problem
Dehumidifier runstoo
much
,i,, ,
Frost appears on the
coils
,=, J i,i
The controlscannot be
set or changed
Fan Noise
,,,,i ,
Water on the floor
PossibleCauses
The area to be dehumidified
is too large.
Doors and windows are
open.
The dehumidifier has recent-
ly been turned on or the
room temperature is below
41°F.
i1,1,,
Bucket is full or it has been
removed.
,,,, ,, i
Air is moving through the
unit.
,,,,,,, , , ,,,,,,,,
Hose connection may be
loose.
,.,.,....
Hose is attached but not
draining into a drain.
Solutions
The capacity of your dehumidifier may not
be adequate for the room size.
Close all doors and windows to the outside.
,,,,,,u,i,,i i,,,,, , ,,,
This is normal. Frost" w ill usually disappear
within 60 minutes.
,, , i iiiiiiii.
Empty bucket and install properly in unit.
This is normal.
... i i,
Check the hose connection.See the Drain-
age Section.
Check hose for obstruction.
Ill Ill I J I I [[111111 I nllnllnnnnnnnllllnnnnln
....... "1
Error Code
F1
F2
Error Type
III
Ambient Tem-
perature Sensor
Malfunction
Possible Cause
III III I
1. Sudden Change in
the surrounding
temperature.
Evaporative
Coil Tempera-
ture Sensor
Malfunction
2. Faulty Sensor
Corrective Action
i1[[ [1 i ii
1. Unplug the dehumidifier.
2. Check the surrounding area for
possible reasons for sudden
:_emperature changes.
3. Wait 30 minutes before plug-
ging the dehumidifier back in
for normal operation.
4. If the "Error" isstill indicated,
please contact your nearest
service center. Call 1-
800-488-1222 for service center
locations.
14