Cleaning The Air Filter; Cleaning The Exterior; Control Panel - Kenmore 407.53530 Use & Care Manual

Table of Contents

Advertisement

Available languages

Available languages

CLEANING
THE AIR FILTER
After 250 hours of operation the FILTER
RESET indicator will light up to remind
you to clean and change the air filter.
It is recommended
to periodically check
the filter for excess dirt even if the
FILTER RESET indicator is off.
1. To remove the air filter, press the two
filter tabs and pull the filter holder
away
from the back of the unit.
2. Remove the filter and clean with
warm, soapy water. Rinse and
allow
the filter to dry before placing back in
the unit.
3. Place the filter back into dehumidifier.
Plug unit back into outlet, power the
unit on and press and hold the FILTER
key up to 5 seconds on the control
panel to reset the filter setting.
NOTE: DO NOT place the filter in a
dishwasher
CAUTION_ DO NOT operate the dehu-
midifier without a filter. Doing so may
cause a unit failure.
WARNING
• Disconnect power supply cord from
receptacle
before performing
any
maintenance.
CLEANING
THE EXTERIOR
Clean the cabinet using a damp cloth
and a mild detergent. Do not use bleach
or abrasives.
CONTROL
PANEL
V_ipe down the control panel with a dry
cloth.
CLEANING
THE BUCKET
Every few weeks, clean the dehumidifier
bucket. Partially fill the bucket with
clean water and mild detergent. Swish
the mixture around in the bucket, empty
and rinse. Replace the bucket when fin-
ished
NOTE: Do not place the bucket in a
dishwasher.
FILTERTABS
I2

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents