Vacuum Cleaner Care - Kenmore COIZDMWOOU00 - KC01ZDMWZOUO Use & Care Manual

WARN,N .........
Electrical Shock And Personal injury
_azard
_)isconnecl electrical supply before per-
forming maintenance to the vacuum
cteanen Failure to do so could result in
electrical shock or personal injury from
vacuum cleaner suddenly starting,
AGITATOR OVERLOAD
PROTECTOR
The agitator has built-in protection
against motor damage should the
agitator jam° if the agitator slows down
or stops, the
agitator overload
Agffatar
,_I
protector shuts off Reset ,//_
the agitator Bulton_--_," //r_-,,..__.
motors.The
vacuum cleaner
suction motor will
continue to run°
To correct problem: Turn off and unplug
vacuum cleaner, remove obstruction, then
press AGITATOR RESET BUTTON.
NOTE: A MINIMUM OF 20 SECONDS
NEEDS TO PASSBEFORE RESETTING
OVERLOAD.
If the problem persists, have the vacuum
cleaner serviced by a Sears or other
qualified technlclan_
DIRT SENSOR
The electronic dirt sensor is a feature
which will detect particles as they pass
through the vacuum cleaner°
The dirt sensor indicators are located on
the nozzle of the vacuum cleaner.
Dirt
Son,of
' When little or no dirt is present the
dirt sensor is green_
* With medium or heavy concentration
the dirt sensor is red_
OPERATION
As you vacuum, the red indicator
light
will come on and stay on as long as the
sensor detects a high concentration of
particles passing through the vacuum
cleaner.
TO CLEAN DIRT SENSOR OPTICS
The dirt sensor optics consist of two optic
ceils located inside the dust cup port°
Occasionally, it may became necessary
to clean the two optic cells to assure
maxlmum performance.
It is recommended the optic cells be
cleaned;
• When the green light stays on
continuously.
• When dirt or dust adheres to the
optic cells°
- Whenever the dust cup is removed,
To clean the
sensor, wlpe the
optic cells with a
soft, dry cloth.
Never use
cleaners or
fiquids as they
can help speed
the recoattng of
the optic ceffs
and make it Dirt sensor
necessary to
clean them much
sooner than
normal The dirt
sensor optic ceils -
can be reached by removing the dust
CUp_
t5