Kenmore 2002 Use & Care Manual page 13

TROUBLESHOOTING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
f
Jf you experience
Washer won't run
or fill, washer stops
working (cont.)
Washer not draining/
spinning_ Roads are
stiH wet
k.
First try the solutions suggested here
for assistance and to possibRy avoid a service caRL
Check proper eRectricaR suppRy.
Normal washer operation.
Washer not loaded as
recommended.
Empty pockets and use garment bags
for small items.
Use a cycle with a Row spin speed.
Washer not Roaded as recommended.
Check plumbing for correct drain hose
installation. Drain hose extends into
standpipe farther than 4.5" (114 ram).
Too much detergent causing suds to
sRow or stop draining and spinning.
Plug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaken Replace any blown fuses.
NOTE: if problems continue, contact an electrician.
Lid must be dosed for washer to run.
Washer will pause during certain phases of cycle. Do not
interrupt cycle.
Washer may be stopped to reduce suds_
Washer spins the load before filling to determine load size.
Remove several items, rearrange load evenly in basket. Close lid
and press START/PAUSE/Unlock Lid.
Do not add more than 1 or 2 additional items after cycle has
started.
Do not add more water to the washen
Small items may have been caught in pump or between basket
and tub_ which can slow draining.
Cycles with lower spin speeds remove less water than cycles
with high spin speeds. Use the recommended cycle//speed spin
for your garment. To remove extra water in the load, select Drain//
Spin. Load may need to be rearranged to allow even
distribution of the load in the basket.
Reduce load size to improve water removal. A tightly packed load
may not allow the washer to spin correctly, leaving the load wetter
than normal.
Check drain hose for proper installation. Use drain hose form
and securely attach to drainpipe or tub. Do not tape over drain
opening. Lower drain hose if the end is higher than 96" (2.4 m)
above the floon Remove any dogs from drain hose.
Always measure and follow detergent directions for your load.
To remove extra suds, select Rinse/Spin. Do not add detergent.
J
13