Kenmore 2536072100B Use & Care Manual page 5

7, To replace door, reverse above order,
This Owner's Guide provides specific operating instructions
for your model, Use the refrigerator only as instructed in this
Owner's Guide, Before starting the refrigerator, follow
these important first steps.
iNSTALLATiON
o Choose a place that is neara grounded electrical outlet,
Do Not use an extension cord or an adapter plug,
o For the most efficient operation, the refrigerator should
be located where surrounding temperatures will not drop
below 10 ° F (°12 ° C) or exceed 110 ° F (48 ° C), The
Freeze Control Feature is designed to automatically
maintain the selected interior refrigerator temperature
within these boundaries,
o A/fowspacearoundthe unitforgoodaircircuiation_
Leave a 3 inch (75 mm) space on all sides of the
refrigerator for adequate circulation,
liiiiiiiilL ?_iiiiii/ii
Installation
NOTE: The exterior walls of the refrigerator may become
quite warm as the compressor works to transfer heat from
the inside, Temperatures as much as 30 ° F warmer than
room temperature can be expected, For this reason it is
particularly important in hotter climates to allow enough
space for air circulation around your refrigerator,
LEVELING
The refrigerator must have all bottom corners resting firmly
on a solid floor, The floor must be strong enough to support
a fully loaded refrigerator, NOTE: it is Very Important for
your refrigerator to be level in order to function properly, if
the refrigerator is not leveled during installation, the door
may be misaligned and not close or seal properly, causing
cooling, frost, or moisture problems,
To LeveJYour Refrigerator:
After discarding crating screws and wood base, use a
carpenter's level to level the refrigerator from front-to-back,
Adjust the plastic leveling feet in front, Y2bubble higher, so
that the door closes easily when left halfway open,
Plastic
Levelirlg Feet
Crating
Screw
And (2) Wood Bases
Unpacking and Leveling
CLEANING
Wash any removable parts of the refrigerator interior, and
exterior with mild detergent and vvarm water, Wipe dry,
Do not use harsh cJeaners on these surfaces.
Do not use razor blades or other sharp instruments,
which can scratch the appliance surface when removing
adhesive labels, Any glue left from the tape can be
removed with a mixture of warm water and mild deter-
gent, or touch the residue with the sticky side of tape
already removed, Do not remove the sedaJ plate.
_To albw door to
close and seal properly, DO NOT let
food packages extend past the front
of shelves,
Sheff Front