Kenmore Three-Speed with Options and Speeds Switch AUTOMATIC WASHERS Owner's Manual & Installation Instructions page 26

CYCLE SELECTOR (TIMER)
CONTROL
Use this control to choose the agitation
time and to start the washer.
• For heavy soil and sturdy fabrics,
use the full time.
• For light soil and delicate fabrics,
use less time.
PERMANENT PRESSI
The PERMANENT PRESS I Cycle
includes a load cooling spray rinse that
reduces wrinkling compared to other
cycles, You can select up to 10 minutes
of wash time.
ULTRA CLEAN
Use this cycle for most loads to get
between 4 and 14 minutes of wash time.
PREWASH
Use this cycle to get up to 4 minutes
of agitation to help remove heavy soils
and stains that need pretreatment,
PREWASH Cycle should be followed
by an ULTRA CLEAN or PERMANENT
PRESS Cycle with additional detergent.
SOAK
SOAK Cycle features 4 minutes of
agitation followed by an unlimited soak
time to help remove heavy soils and
stains that need pretreatment. You will
need to reset the washer to a SPIN
setting to remove water. SOAK Cycle
should be followed by an ULTRA
CLEAN, PERMANENT PRESS, or
PREWASH Cycle with additional
detergent.
NOTE: We do not recommend hot water
for soaking. It may set some stains.
PERMANENT PRESSII
The PERMANENT PRESS II Cycle
includes a load cooling process
that reduces wrinkling compared
to other cycles.
You can select up to 10 minutes of
wash time.
NOTE: When the timer reaches PAUSE,
the washer will drain and pause for no
more than two minutes while some of
the wash water is drained and replaced
with rinse water.
26