Kenmore Three-Speed with Options and Speeds Switch AUTOMATIC WASHERS Owner's Manual & Installation Instructions page 12

LAUNDRY TUB DRAIN SYSTEM
Check location where washer will be
installed. This washer can be installed us-
ing one of three systems:
• Laundry tub drain system (below)
• Standpipe drain system (p. 13)
• Floor drain system (p. 13)
Do not store or operate washer at or
below 32°F (0°C) (some water may
remain in washer). See page 34 for
winterizing information.
Proper installation is your responsibility.
Make sure you have everything neces-
sary for correct installation including the
following points:
Grounded receptacle: Must Hot and cold water faucets:
be within 4 ft (1.2 m) of where Must provide water pressure
the power cord is attached to between 5-100 psi and be
the back of the washer, within 4 ft (1.2 m) of the hot
/ and cold water fill valves
J attached to the back of the .....
/ washer Launary tub aram system:
/_ " _ Needs a minimum 20 gal
/ _ (76 L) laundry tub.
// _\
/
p e at
/ least 39 in (99 cm)
Support: Floor must be sturdy Level floor: Maximum above floor and no
enough to support a total weight allowable slope under entire higher than 96 in
of 315 Ibs (143 kg) (includes washer- 1 in (2.5 cm). (2.4 m) from bottom
washer, water, and Ioad weight), of washer.
12