Installation; Door Opening - Kenmore 218949500 (9905) Owner's Manual

This Owner's Guide provides specific operating instructions
for your model. Use the refrigerator only as instructed in
this Owner's Guide. Before starting the refrigerator,
follow these important first steps,
LOCATION
• Choose a place that is near a grounded electrical
outlet. Do Not use an extension cord or an adapter
plug,
o if possible, place the refrigerator out of direct sunlight
and away from the range, dishwasher or other heat
sources.
• The refrigerator must be installed on a floor that is
level and strong enough to support a fully loaded
refrigerator_
• Consider water supply availability for models eqtJipped
with an automatic ice maker,.
INSTALLATION
° Do not install the refrigerator where temperature will
drop below 60°F (I 5°C) or rise above 110°F (43°C)o
The compressor will not be able to maintain proper
temperatures°
° in a recessed installation, allow an extra 1/2 inch
(10-15 mm) on each side, for ease of installation,
° To permit proper door swing, if the hinge side of the unit
wil! be placed against a wall, allow a 1- 3/4 inch
(44 mm) space between the wall and the refrigerator.
DOOR OPENING
The doors should open to allow easy access to a counter
when removing food°
° Do not position the refrigerator so you have to walk
around the refrigerator doors.
LEVELING
• Refrigerator must be leveled with all bottom corners
resting firmly on a solid floor. Adjust front rollers to
level cabinet both front-to-rear and side-to-side. Keep
cabinet as low as possible for stability,. Never adjust
cabinet rollers so front is lower than rear.
• To adjust front rollers: Open refrigerator and freezer
doors° Remove toe grille by pulling it straight ouL
Adjust rollers by turning each roller adjusting bolt with
an adjustable wrench, a socket wrench, or a nutdriver
until the refrigerator is level and stable. Rear rollers
are not adjustable.
° Check both doors to ensure the seals touch the
cabinet evenly on all four corners.
• If freezer door is higher than refrigerator door,
raise right corner and/or lower left comer until doors
align across top of cabinet.
° If refrigerator door is higher than freezer door,
raise left corner and/or lower right corner until doors
align across top of cabineL
Roller Adjusting Boff
Adi_sting Front Rollers
Replacing Toe Grille
° To replace toe grille: Line up tabs with holes, and
push grille straight on,
CLEANING
° Wash the inside, all removable parts, and theoutside
with mild detergent and warm water° Wipe dry° Do Not
use harsh cleaners on these surfaces,
° Do not use razor bfades or other sharp instruments
that can scratch appliance surface, when removing
adhesive tabels_ Any glue left from tape or energy label
can be removed with a mixture of warm water and mild
detergent, or touch residue with sticky side of tape
already removed.
° Do not remove the Serial Plate.
5