Put Thread On The Spool - Kenmore 19502 Owner's Manual

Prepare the Bobbin
Put Thread on the Spool
Ordinary spool
pin
Small spool
Small "_'_ z___________________ F Spool
NOTE: Your spool pin tilts upward for
ease in putting thread on the
spool,
You have two spool holders:
large (under the top cover)
Iin your accessory box).
1.
and small
Choose the appropriate spool holder.
2. Place your thread on the spool pin and
then fit the spool holder down over it,
so that the thread winds toward the
back of the machine, as shown.
3. Press the spool holder against the spool.
4. Lower the spool into the well.
18
NOTE:
Additional Spool Pin
/Spool
p_l
._ _-U_ felt
I _-Addhiona'
_V" _spool
pln
Spo_
hole
.................. J
For winding the bobbin while your machine is threaded, you have an extra
SpooJ pin in your accessory box, tt fits into the square hole on top of
your machine near the bobbin winder.
To Use Thts Extra Spool Pin:
1. Fit the square end of the spool pin into the square bote, as shown.
2. Fit the spool pin felt on the base of the spool pro,
3. Put your spool of thread on top of the felt, with the thread winding m the
direction shown. See directions for winding the bobbin, p. 19 _ 20.