Kenmore 19502 Owner's Manual page 69

Bu o,.o, I Co. ..odi
= Adjust the Stitch Density
You can adjust the stitch density of the entire
buttonhole or of only one side.
The stitch length button controls the stitch
density, it is pre-set at "0.4"
Set the Machine
_ Pre_s
Fine Coarse
stitches st wtches
Ststch DensLty in Entire Buttonhole:
Press "+" or "--'" to adjust the stitch density of
the entire buttonhofe.
68
St=tch Density on One Side:
The stitches on each s=de of the buttonhole should
be the same stitch density. To adjust, use the feed
balance dial below the Hand Wheel.
A B
For Condition A: For Condition 8:
Left Side Stitches too Far Apart Right Side Stitches too Far Apart
_see above) (see above)
Turn the feed balance diaf slightly Turn the feed balance dial slightly
toward "-". Use the large screw toward "+",
dr=vet m your accessory box.
After adjusting the feed balance dial, sew another test buttonhole to be sure
your adjustment is correct.
NOTE: Remember to turn the feed balance dial to the standard mark
( _ ) when you have completed your buttonholes,