Kenmore 580.72087200 Owner's Manual page 11

PROCEDURE C
W Remove the backing from the 13" shim strips
and attach them as shown below in Fig. 21.
The higher portion of shim is to be placed in
front of the rib on the base of wall sleeve.
h'0h E--' 'I'"0h
FIG. 20
FIG. 21
_r_ Install the new unit into the wall sleeve
_"_To assemble trim, snap the tab of each piece
into the slot of the other piece as shown below.
Slide trim over the front of the air conditioner
until trim is flush with sleeve as shown below.
Trim (2 ea)
Wall
FIG. 22
[!_ [_f_,_liI [.] _I
• Air conditioners covered in this manual pose
an excessive weight hazard. Two or more
people are needed to move and install the unit.
To prevent injury or strain, use proper lifting
and carrying techniques when moving unit.
• When handling the air conditioner, be careful
to avoid cuts from sharp metal fins on front and
rear coils.
• Make sure air conditioner does not fall during
removal.
-11-